TechWorks ECS Controller Jumper Settings ECS M01 PCB Rev1.2

The Following applies Only to TechWorks ECS Controllers that are using the ECS M01 PCB v1.2 AND Firmware Version 1.8 or greater.


The following pictures show how to configure the TechWorks ECS Controller Jumper settings for the following

o Use Large LEDs or Small LEDs


o Use Rotary Switch or Push Button Factory Switch

Push Button Switch Large LEDs JumperConfig


TechWorks Push Button SwitchSmall LEDsJumper Config

TechWorks Rotary Switch Large LEDs Jumper Config


TechWorks RotarySwitch SmallLEDs JumperConfig